Pureit Mineral Ultima RO+UV+MF

Pureit Mineral Ultima RO+UV+MF

Digital Advanced Alert System

Digital Advanced Alert System

RO Protection Lock

RO Protection Lock

100% RO and UV

100% RO and UV

Guided Alert System

Guided Alert System

৳ 26,000 ৳ 25,000*
Request a Home Demo Add to Cart

*MRP (inclusive of all taxes) for 1 unit.

*Free home delivery and installation.

Device Details

fa35dc2e88b1f78338333b0d50383c25.png

About the Device

Pureit Ultima RO + UV comes with an advanced technology that digitally
shows you, how pure your drinking water is.

a84bb92541f66263e25de2ed9e26a704.png

Purity~ Indicator

Senses water quality^ up to 5000 times a second^^ to show^^^
how pure your water is.

dd1ecf9b2cd2777936d97d2b5546910b.png

Digital Display Panel

An electronic panel that digitally shows the quality^ of water as well as
life of Germkill Kit™.

Digital Advanced Alert System
Digital Advanced Alert System

The two concentric circles alert you 15 days# before the life of Germkill Kit™ gets over

100% RO and UV
100% RO and UV

100% water passes through RO and UV to give you completely safe and pure drinking water

TDS Modulator
TDS Modulator

Adds minerals post purification to enhance the taste of water

RO Protection Lock
RO Protection Lock

Once the Germkill Kit™ life is over, it automatically stops the flow of water so that you get pure water

Guided Alert System
Guided Alert System

In case of specific electrical faults, a segment of red band will illuminate where the fault is.

7-Stage Purification
7-Stage Purification

Turns hard water upto TDS 2000 ppm into soft and sweet water through RO + UV technology.

Device Image

10 Litre Water Storage Capacity

Specifications for Water Purifier

Purified Water Flow Rate (Average)*
Purified Water Flow Rate (Average)*

Approximately 12 -15 Litre per hour

Membrane Type
Membrane Type

Thin film composite spiral wound

Pump Type
Pump Type

Diaphragm pump 24V DC

% Recovery **
% Recovery **

Typically 25%

TDS Reduction***
TDS Reduction***

90% (Min)

Power Rating
Power Rating

60 Watts

Pressure Rating
Pressure Rating

10–30 PSI

Operating Voltage
Operating Voltage

100–240 Va.c 50/60 Hz (100–300 Va.c 50/60 Hz)

Material of Construction
Material of Construction

Food grade, non-toxic, engineering grade plastics

Length of Power Adapter
Length of Power Adapter

1.5 metres

Total Dissolved Solids
Total Dissolved Solids

Upto 2000 mg/lit

Total Hardness
Total Hardness

500 mg/lit (max)

Iron in Input Water
Iron in Input Water

0.3 mg/lit (max)

Turbidity of Input Water
Turbidity of Input Water

1 NTU (Max)

Purification Capacity
Purification Capacity

Germkill Kit™ -1 is designed to give approximately 4000L^ of purified water and Germkill Kit™ -2 gives approximately 8000L^ of purified water respectively depending on input water pressure, TDS and water temperature

Material of Construction
Material of Construction

Food safe, non-toxic, engineering-grade plastics

Purification Capacity (CSF Germkill Kit ™)
Purification Capacity (CSF Germkill Kit ™)

Removes dissolved salts, hardness, pesticides and heavy metals like lead and mercury. It also removes microbial contaminants like bacteria, virus, protozoa and cysts

Germkill Performance Standard
Germkill Performance Standard

Meets stringent international criteria for microbiologically safe drinking water, such as Environmental Protection Agency (EPA), USA

Pureit Ultima RO+UV has a 7 stage purification process that removes invisible and harmful new age contaminants like lead and mercury along with excess Total Dissolved Solids (TDS) to make your water tastier. Stage 1 – Pre-Sediment Filter Removes fine and coarse particulate impurities/dirt and improves life of the Carbon Filter. Stage 2 – Pre-RO Carbon Filter Removes chlorine and organic impurities like harmful pesticides. It also absorbs bad taste odour causing organic compounds from water Stage 3 – Post RO Carbon Sediment Filter Removes fine and coarse particulate impurities/dirt and improves life of RO membrane. Stage 4 RO Membrane Removes dissolved salts, hardness, pesticides, fluoride and heavy metals like arsenic, lead and mercury. It also removes microbial contaminants like bacteria, virus, protozoa and cysts. Stage 5 UV Reactor Acts as an additional stage of purification to further inactive bacteria, virus and parasites to deliver safe water Stage 6 Natural Taste Enhancer Last level of purification acts as a polisher and enhances the taste of purified water Stage 7 Micro Filtration Membrane (MF) Micro Filtration (MF) is added post-RO, which ensures that the water is purified not once but thrice

Pureit has storage tank capacity of upto 10 litres. With no continuous input water, the average dispense capacity is 9.2 litres. The storage tank is fully automatic and well shielded. When you take water of the tank, the purification process starts automatically again and refills the storage tank.

Pureit can purify water up to 15 litres per hour depending on the device you have purchased. However, the time taken to purify depend on the life of the filters, the input water pressure, TDS and other impurities present in water

You need to call the Pureit Helpline and order the consumables. The customer care specialist will visit your place and replace the consumable/Germkill Kit at a nominal cost.

In case you cannot dispense water from the tap, then you need to first check whether the power supply is on. If it is on, then check if there are any fault indicators illuminated, or “ CHANGE GKK” and the Call Centre Number is illuminated on the Digital Display Panel. Call the Pureit Helpline and get either the fault resolved or Germkill Kit replaced. If none of these lights are illuminated on the Digital Display Panel, then check if the Ball Valve is closed. If none of these case are true, then please call Pureit Helpline for assistance

Pureit Mineral RO+UV will purify potable water for removal of hardness and other impurities to give you safe drinking water. if the input water has impurities normally not present in drinking water (high iron/turbidity/microbial contamination etc.) or water is from unknown resource (river /lake /pond / borewell etc.) then suitable pre-treatments may be required.

It is not recommended to open and service device by an individual. Call our Pureit Helpline if you face any issue which requires servicing and opening the device.

There may be several reasons for this: While the Germkill Kits and the Pre-Sediment Filter have fixed replacements schedules, depending upon your input water quality the Pre-Sediment Filter might need a replacement even before your Purifier gives you the alert. In such cases, please contact the Pureit Helpline and get Presediment Filter replaced. The purifier will communicate the alert only if the purifier is in a switched on condition during the scheduled alert time. Post the completion of the scheduled alert time, Auto Shut off™ of water will be activated automatically, even if the purifier is in a switched off condition.

While the Germkill Kits™ and the Pre-Sediment Filter have a fixed replacement schedule, you might be required to change the filters in the interim depending on the quality of your input water. Should the tap floow rate be very less or if it is taking too long for the tank to fill, then please contact the Pureit helpline to change the membranes. These extra visits will be chargeable as per T&C.

No, recommendation is to throw the first cycle of water that is filled in the storage tank when the new Pureit purifier is installed and also whenever the Germkill Kit are replaced.

It is not recommend to open and service purifier by an individual. Call our Pureit Helpline if you face any issue which requires servicing and opening of the purifier

You can used stored water for 2 days. If it is not used for more than 2 days we advise you to discard that water, refill and then consume

~ “Purity” here refers to the TDS range of water

^ “Quality” here refers to the TDS range of water

^^ Depend on your water quality

^^^ You can see the quality of water through the purity indicator only when water is being purified or the purifier is in use

# Advance Alert SystemTM will alert you 15 days before every 180 days (approximately) or 15 hours before completion of every 200 hours of pump running time, whichever is earlier. The purifier will communicate the alert only if the purifier is in switched-on condition during the scheduled alert time. Post the completion of the scheduled alert time, Auto Shut-OffTM of water will be activated automatically for GKK only, even if the purifier is in switched-off condition.

* Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality, TDS, pressure and life of Filter elements

** 10 litres of storage only with running water. Or else 9.2 litres of water dispensing.

*** Input water quality and TDS content are important determinants of output water quality.

**** If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If the pressure is lesser than 10 PSI, then you need to buy 'Pressure enhancing pump at an additional cost. Device should not be installed in a house where input pressure is greater than 60 psi.

##Technical specifications are subject to change or improvement without prior notice

### In case the TDS is > 1000 ppm, a company provided anti-scalant is recommended to be installed, this has to be purchased at extra cost.

#### If the iron content in the input water is more, it is recommended to install a company provided iron filter.

Physical product may vary from the image on the website

Contact

Call to Pureit Careline 16627 - 8:00AM to 12:00 Midnight (everyday) or send us an email at pureit.bd@unilever.com

Home Demo