Pureit Ultima RO + UV + MF comes with an advanced technology that digitally
shows you, how pure your drinking water is.
Senses water quality^ up to 5000 times a second^^ to show^^^
how pure your water is.
An electronic panel that digitally shows the quality^ of water as well as
life of Germkill Kit™.
The two concentric circles alert you 15 days# before the life of Germkill Kit™ gets over
Once the Germkill Kit™ life is over, it automatically stops the flow of water so that you get pure water
100% water passes through RO and UV to give you completely safe and pure drinking water
In case of specific electrical faults, a segment of red band will illuminate where the fault is.
Adds minerals post purification to enhance the taste of water
Turns hard water upto TDS 2000 ppm into soft and sweet water through RO + UV technology.
Germkill Kit™ -1 is designed to give approximately 4000L^ of purified water and Germkill Kit™ -2 gives approximately 8000L^ of purified water respectively depending on input water pressure, TDS and water temperature
Food safe, non-toxic, engineering-grade plastics
Removes dissolved salts, hardness, pesticides and heavy metals like arsenic, lead and mercury. It also removes microbial contaminants like bacteria, virus, protozoa and cysts
Meets stringent international criteria for microbiologically safe drinking water, such as Environmental Protection Agency (EPA), USA
Pureit Ultima RO+UV+MF has a 7 stage purification process that removes invisible and harmful new age contaminants like lead, arsenic and mercury along with excess Total Dissolved Solids (TDS) to make your water tastier. Stage 1 – Pre-Sediment Filter Removes fine and coarse particulate impurities/dirt and improves life of the Carbon Filter. Stage 2 – Pre-RO Carbon Filter Removes chlorine and organic impurities like harmful pesticides. It also absorbs bad taste odour causing organic compounds from water Stage 3 – Post RO Carbon Sediment Filter Removes fine and coarse particulate impurities/dirt and improves life of RO membrane. Stage 4 RO Membrane Removes dissolved salts, hardness, pesticides, fluoride and heavy metals like arsenic, lead and mercury. It also removes microbial contaminants like bacteria, virus, protozoa and cysts. Stage 5 UV Reactor Acts as an additional stage of purification to further inactive bacteria, virus and parasites to deliver safe water Stage 6 Natural Taste Enhancer Last level of purification acts as a polisher and enhances the taste of purified water Stage 7 Micro Filtration Membrane (MF) Micro Filtration (MF) is added post-RO, which ensures that the water is purified not once but thrice
Pureit has storage tank capacity of upto 10 litres. With no continuous input water, the average dispense capacity is 9.2 litres. The storage tank is fully automatic and well shielded. When you take water of the tank, the purification process starts automatically again and refills the storage tank.
Pureit can purify water up to 15 litres per hour depending on the device you have purchased. However, the time taken to purify depend on the life of the filters, the input water pressure, TDS and other impurities present in water
You need to call the Pureit Helpline and order the consumables. The customer care specialist will visit your place and replace the consumable/Germkill Kit at a nominal cost.
~ “Purity” here refers to the TDS range of water
^ “Quality” here refers to the TDS range of water
^^ Depend on your water quality
^^^ You can see the quality of water through the purity indicator only when water is being purified or the purifier is in use
# Advance Alert SystemTM will alert you 15 days before every 180 days (approximately) or 15 hours before completion of every 200 hours of pump running time, whichever is earlier. The purifier will communicate the alert only if the purifier is in switched-on condition during the scheduled alert time. Post the completion of the scheduled alert time, Auto Shut-OffTM of water will be activated automatically for GKK only, even if the purifier is in switched-off condition.
* Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality, TDS, pressure and life of Filter elements
** 10 litres of storage only with running water. Or else 9.2 litres of water dispensing.
*** Input water quality and TDS content are important determinants of output water quality.
**** If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If the pressure is lesser than 10 PSI, then you need to buy 'Pressure enhancing pump at an additional cost. Device should not be installed in a house where input pressure is greater than 60 psi.
##Technical specifications are subject to change or improvement without prior notice
### In case the TDS is > 1000 ppm, a company provided anti-scalant is recommended to be installed, this has to be purchased at extra cost.
#### If the iron content in the input water is more, it is recommended to install a company provided iron filter.
Physical product may vary from the image on the website