Pureit Marina Prime 7 L RO + MF Water Purifier

Pureit Marina Prime has a 6-stage purification process which ensures you to get water that is ‘As Safe As Boiled Water’ and also removes excess Total Dissolved Solids (TDS) to make your water tastier.
Stage 1st: i-Sediment Filter:
Removes fine and coarse particulate impurities/dirt and improves the life of the Carbon Filter.
Stage 2nd: Pre-RO Carbon Filter:
Removes chlorine and organic impurities like harmful pesticides. It also absorbs bad taste odour causing organic compounds from water.
Stage 3rd: i-Sediment Filter+:
Filters water further to ensure removal of finer particulate impurities.
Stage 4th: Reverse Osmosis Membrane:
Removes bacteria and viruses causing water borne diseases like Typhoid, Jaundice, Diarrhea etc.
Stage 5th: Post Carbon Filter:
The level of purification acts as a polisher and enhances the taste of purified water.
Stage 6th: Microfiltration Filter:
Micro Filtration Membrane is stage after Post-RO, which ensures the extra safe drinking water from bacteria & viruses with an additional filtration.

Pureit Marina Prime has Storage Tank capacity of up to 7 litres under running water conditions. The storage tank is fully automatic and well shielded and as and when you take water out of the tank, the purification process starts automatically again and refills the storage tank.

Pureit Marina Prime can purify water up to 20 litres per hour depending on the device you have purchased. However, the time taken to purify depends on the life of the filters, the input water pressure, TDS and other impurities present in the water.

Like other ions, the RO technology can also remove fluoride and nitrates.

You need to call the Pureit helpline and order the consumables. The customer care specialist will visit your place and replace the consumable/Germkill Kit at a nominal cost.

You need to replace / clean the sediment filter basis water quality and GKK approximately every 2 year from date of installation.

No, our recommendation is to throw the first cycle of water that is filled in the storage tank when the new Pureit purifier is installed and also whenever the Germkill Kit is replaced.

It is not recommended to open and service purifier by an individual. Call our Pureit helpline if you face any issue which requires servicing and opening of the purifier.

It is not recommended to use the reject water for any kind of human/pets consumption (drinking or cooking). It may be used for gardening or cleaning floors.

Please call the Pureit helpline. Our technicians will visit your house and guide you on the repairs required. There will be a nominal visiting charge and you would need to buy the parts required.

First switch off the ball valve if you find any leakage from the purifier and turn off the power switch. Check for any visual improper fitment and then call our Pureit helpline number and register a service request.

You can use stored water for 2 days. If it is not used for more than 2 days, discard the water stored in purifier tank by dispensing water from purifier tap and flush purifier for two complete cycles around 12 ltrs. by dispensing it from purifier tap.